Development process
Since the printed circuit board is not a general terminal product, the definition of the name is a bit confusing. For example, the motherboard for personal computers is called the motherboard and cannot be called directly It is a circuit board. Although there are circuit boards in the motherboard, they are not the same. Therefore, when evaluating the industry, the two are related but cannot be said to be the same. Another example: because there are integrated circuit parts mounted on the circuit board, the news media call it an IC board, but in fact it is not the same as a printed circuit board.
Under the prerequisite that electronic products tend to be multi-functional and complex, the contact distance of integrated circuit components has been reduced, and the speed of signal transmission has been relatively improved. The length of the wiring between the points is locally shortened, which requires the application of high-density circuit configuration and microvia technology to achieve the goal. Wiring and jumper are basically difficult to achieve for single and double panels. Therefore, the circuit board will be multi-layered, and due to the continuous increase of signal lines, more power and ground layers are necessary means for design. All of these have made the Multilayer Printed Circuit Board (Multilayer Printed Circuit Board) more common.
Advantages
For the electrical requirements of high-speed signals, the circuit board must provide impedance control with AC characteristics, high-frequency transmission capabilities, and reduce unnecessary radiation (EMI). With the structure of Stripline and Microstrip, multi-layer design becomes a necessary design. In order to reduce the quality problems of signal transmission, insulating materials with low dielectric coefficient and low attenuation rate are used. To cope with the miniaturization and arraying of electronic components, the density of circuit boards is continuously increased to meet demand. The emergence of component assembly methods such as BGA (Ball Grid Array), CSP (Chip Scale Package), DCA (Direct Chip Attachment), etc., has promoted printed circuit boards to an unprecedented high-density state.
Any hole with a diameter less than 150um is called a microvia in the industry. The circuit made by using this microvia geometry technology can improve the efficiency of assembly, space utilization, etc., at the same time It is also necessary for the miniaturization of electronic products.
For circuit board products of this kind of structure, the industry has had many different names to call such circuit boards. For example: European and American companies used to use sequential construction methods for their programs, so they called this type of product SBU (Sequence Build Up Process), which is generally translated as "Sequence Build Up Process." As for the Japanese industry, because the pore structure produced by this type of product is much smaller than that of the previous hole, the production technology of this type of product is called MVP (Micro Via Process), which is generally translated as "Micro Via Process." Some people call this type of circuit board BUM (Build Up Multilayer Board) because the traditional multi-layer board is called MLB (Multilayer Board), which is generally translated as "build-up multilayer board".
Origin of the name
The IPC Circuit Board Association of the United States proposed to call this type of product the common name of HDI (High Density Intrerconnection Technology) for the sake of avoiding confusion. If Direct translation becomes a high-density connection technology. However, this cannot reflect the characteristics of the circuit board, so most circuit board manufacturers call this type of product HDI board or the full Chinese name "High Density Interconnection Technology". But because of the problem of the smoothness of spoken language, some people directly call this type of product "high-density circuit board" or HDI board.